Not Appearing Message in EC Admin

I created a Data flow for a process bod and every thing is good in that and i am dropping a file in input folder then i am receiving an output in view, till here going good but when i am triggering the BOD in MBM initiator i am not finding any finished message or detection failed message in EC Admin.

Please can anyone suggest me a solution for this.

Find more posts tagged with

Accepted answers

All comments

Legacy Contributor

Hi

your post is a bit confusing, when you say you drop a file in the input folder I assume that you are trying to load a file to M3 and process it using MEC mapper.

At the same time, you mentioned when you trigger the BOD in the MBM initiator and you didn't find any finished message. Does it mean are you trying to print a file in M3 and capture it using the MBM initiator, which means this one is from M3 to ION correct?

For the MBM initiator message, we need the event rules for the print file, BOD processor entry.

it would be good you give a clear picture of this like below.

M3->ION->3rd party location
or
3rd pardty location -> ION -> M3

Legacy Contributor

Actually i am dropping in SFTP folder and going to M3

And also got to know that if we are triggering in MBM then we need to create another DF i.e, From M3 application to EC

Legacy Contributor

Yes, in MT if you want to capture an event on a print file then you can setup config in CRS945 and CRS949 and capture the event in Event analytics where you can route it to the BOD using Bod NOUN field in event analytics and the same BOD noun has to be added in BOD processor.

Please check whether your MBM trigger is working you can check this in Event Hub, if you are able to see your event here then your M3 configuration is valid and you move to the next step and check the event rules and then BOD processor entry.

make sure the BOD noun naming matches in event analytics, BOD processor, and MEC mapper.

Copyright © 2025 Infor. All rights reserved.