Punch Out ID in EDI 850

Is anyone is sending the punch out ID in an 850 message?. If so, what is the setup? We are implementing punch out in conjunction with EDI for Amazon and they require that we send the punch out ID in the EDI message.

Find more posts tagged with

Infor Lawson Supply Chain Group - Discussion

Comments

unknown

No - I would open a web chat in Lawson and see if it's even an option.

unknown

Did you ever find a solution for this? Amazon is insisting the same from us, and the Infor GSC official statement is Working As Designed even though Amazon is on the Punchout supported vendor list. Looking at a modification to the Lawson delivered X12 map which I'd prefer not to do.

unknown

Not sure about the punchout id, but we have Punchout with Amazon and they required a SupplierPartAuxiliaryID for each item that was ordered. I had to make a copy of the 850 perl script and modify it to meet their requirements. It took a lot of testing to get it right. I also had to map the SupplierPartAuxiliaryID to the Deliver To field in the rqc_confix.xml file because I couldn't find another spot for it that I could reference in the script. Needles to say the Purchasing staff is not happy with it.

unknown

Excellent info JimY - This story is coming together. Apparently Amazon is using the term "SupplierPartAuxiliaryID" for this exact issue as that is the field in XML. I have now found KB 1509400 for this issue with JT-537016 and JT-607146 but it's been assigned a Severity of "High" since June 2014 and still shows "Candidate for Development". The proposed fix would pass the data into the PO120 output which is half the battle - the PERL script would still need to map it, but there's something there to map (You wouldn't have to use the Deliver To field) I'm going to push this with our Infor contact - I wouldn't be disappointed if you wanted to run this by your rep as well. THANKS AGAIN!

unknown

Thank you for the information on the KB articles. I wasn't aware of them.

Jimmie Smith

Did anyone ever get Amazon set up to run either via EDI or cXML? We are looking to set up Amazon on punchout. We prefer EDI, but I have not found a way to send the ID they want. Infor states they are only 'approved' for cXML. Either way - I'm not sure how to go about setting up this SupplierPartAuxiliaryID so that it will pass from the session back into the PO. (If I understand the use correctly)

If anyone could share set up ideas or suggestions that would be most appreciated. I don't want to have to create a special one off process for one vendor especially since we are looking at moving to cloudsuite in the next year or so.

0911060553270289.pdf

Copyright © 2025 Infor. All rights reserved.