IC527 Interfacing with Picis - Surgical Supply System of items used during a surgical case

We use IC527 to interface item data to Picis - Surgical Supply System of items used during a surgical case.

The items are set up within a specific par area.

We have had many problems with IC527 not triggering correctly. Therefore the Picis system was not updated with the correct information.

Is there anyone else that uses Picis and have you encountered any problems interfacing with IC527.

Find more posts tagged with

Infor Lawson Supply Chain Group - Discussion

Comments

Stace Webley

Yes, we found that we needed to put a 'C' fc code on the par line (IC81.1) and the click change to get changes to go through if anything was ever updated on the item.

todd-brown

We use IC527 for this Picis interface as well. No know issues, or at least no one on the Picis side has brought it up.

unknown

We have not been with PICIS since 2013, but when we were with them we would have issues similar to this - the IC12 wouldn't register a change and not trigger. We would create a negative IC21 to add 1 EA to the item then IC21 the item back out. It was enough "movement" trigger the IC527.

We also had issues with the IC527 versions suddenly sending purchase cost instead of EA periodically.

Copyright © 2025 Infor. All rights reserved.