Enabling LSR at the program level

Has anyone been able to successfully enable LSR Lawson Smart Reports at the program level? We’ve created the .cfg file and dropped in the suggested directory (%LAWDIR%productlinenameobjPROGRAMCODE.cfg) and ensured %LAWDIR%system
pt.cfg, RPT_CFG_OVRD is OFF, but it throws the job into recovery instantly. Once removed it runs perfectly fine. I've tried with a couple different programs and the results have been the same. I have an incident open, but wanted to see if anyone has experienced or successfully enable this. We're on ESP 10.0.9 and MSP 10.0.7. Thanks.

Find more posts tagged with

Infor Lawson Supply Chain Management - Discussion

Comments

Jim Norbut

I thought it was supposed to be under %LAWDIR%productlinename??srcPROGRAMCODE.cfg where ?? is AP/GL/PO/PR....etc

I've found that the lines in the .cfg file sometimes are tricky to get right

mine has

RUNTIME_XML ON

RUNTIME_XML_ENABLE ON

LSR_ENABLE ON

but if you have an extra space at the end of a line

or another blank line at the end....it can cause havoc.

just my 2cents.

lxiong3

Thanks Jim.

Validated there were no extra spaces or blank line at the end of the .cfg. Yes, you can use that directory as well per documentation and we've tried both with no success.

unknown

I was experiencing the same issue as you described. Instead of creating the file via notepad.exe, I used LID and the lx command (which apparently is a text editor in LID).

Some text editors add an extra line, or end the file differently so I suspect that was what the issue was in our case.

Copyright © 2025 Infor. All rights reserved.