Barcode Label Printing

Is anyone printing par item labels directly from Lawson or Crystal Reports to a Zebra or other continuous feed barcode printer without the use of a third party label maker program or MSCM?

Find more posts tagged with

Infor Lawson Supply Chain Management - Discussion

Comments

unknown

Yes we print from a crystal report to a Zebra for our shelf labels. What did you need?
My e-mail is guldner@genesishealth.com if you want to e-mail me about it.
'

todd-brown

Anyone printing directly from MSCM to a Zebra printer?

0712131256598360.doc

unknown

Yes, we print from MSCM directly to a Zebra printer. How can I help you?

todd-brown

Okay, we just got our printer and got it installed, went in and printed an item label. It did print. We have 4x2 size labels, but the print was all contained in like 1 square inch of space on the label. So I need to make that bigger

VID046_Form Validation Rules.zip

unknown

Did you do a Calibration on the printer? This will typically determine the label length and sensor settings. Check the printer manual for instructions.

todd-brown

It is supposed to calibrate when it powers up. Restarted it many times

todd-brown

We are using a zebra zt230 printer

unknown

Hmmm - we don't have that printer. We have the ZM400 and haven't seen that issue. Sorry - perhaps someone else has seen this. Ours just printed appropriately after the first calibration. Are you using Zebra labels?

todd-brown

How did you calibrate it. We tested this on a 400 as well. Same issue.

unknown

Your manual will explain how to auto calibrate or manual calibrate. If you don't have a manual, check out the link below. We just followed the instructions. Not sure if it matters but we're using smaller labels (1in x 3in).
www.zebra.com/.../zm400.html

Click on the "Manuals" tab and look for your printer.

Copyright © 2025 Infor. All rights reserved.