Cyclic Inventory Issue in MMS300 and MMS301
I am working with a Cyclic Inventory in MMS300 and have completed the following steps:
- Created Physical Inventory Lines
- Updated Physical Inventory Lines
- Created and updated Variance Lines
After completing these steps, the Inventory status in MMS300 is updated to 70, which is expected. Ideally, there should be no lines left in the MMS301 panel. However, in my case, out of 27 lines, only one line is stuck in MMS301. This issue has occurred 2-3 times with different Physical Inventory cycles.
I have checked the configuration in MMS002 for the affected item, but I am unable to determine the root cause of why these few lines are getting stuck in MMS301. Has anyone faced a similar issue or can provide insight into possible causes?
Regards,
Thakur
